Unlock Huawei Y9 2019 Frp Using TestPoint: A Curious Technique
Huawei Y9 2019 Frp Bypass With TestPoint Method JKM-LX1, JKM-LX2
Hello Everyone and Welcome Back to My YouTube Channel
Today, I’m going to be showing you how to remove factory protection on the Hway device Hway Y9 2019.
Introduction
All right, so in this video, I will be demonstrating the process of removing the factory protection on the Hway Y9 2019. This device is known for its Google account lock, which can be quite frustrating for users. However, with the right tools and techniques, you can successfully bypass this protection and gain access to your device.
Step 1: Removing the Back Cover
First and foremost, you’ll need to remove the back cover of the device to access the internals. Carefully remove the back cover to reveal the inner components of the phone. This step is crucial for the upcoming procedures, so make sure to handle the device with care.
Step 2: Checking for Google Account Lock
Next, power on the device and proceed with the setup process. As you navigate through the initial setup, you’ll encounter the Google account lock screen prompting you to verify your identity. This is a common security measure implemented by manufacturers to deter unauthorized access to the device.
Step 3: Locating the Test Point
To bypass the Google account lock, you’ll need to locate the test point on the device. The test point is a specific area on the circuit board that, when short-circuited, allows for the bypass of certain security measures. In this case, we will be shorting two points on the board to initiate the bypass process.
Step 4: Connecting the Test Point
Carefully connect the test point by shorting the designated points on the circuit board. This step requires precision and caution to avoid damaging the device. Once the test points are successfully connected, proceed to connect the device to your computer using a compatible cable.
Step 5: Installing Drivers and Software
Before proceeding further, ensure that the necessary drivers for the device are installed on your computer. This will enable proper communication between the device and the software used for the bypass process. Install the required drivers and software, such as Octoplus 2, to proceed with the bypass process.
Step 6: Initiating the Bypass Process
With the test points connected and the device properly connected to your computer, navigate to the device manager to verify the connection. You should see the device listed as “Hway USB com 1.0”, indicating that the test point bypass was successful. If the device is not recognized, install additional drivers or software to establish the connection.
Step 7: Resetting the FRP
Once the device is recognized by the computer, proceed to reset the FRP (Factory Reset Protection) using the software. This process will remove the Google account lock and allow you to access the device without any restrictions. Follow the on-screen instructions to complete the bypass process successfully.
Conclusion
In conclusion, removing factory protection on the Hway Y9 2019 device may seem like a daunting task, but with the right tools and techniques, it can be accomplished successfully. By following the steps outlined in this video, you can bypass the Google account lock and regain access to your device. Remember to exercise caution and precision when performing these procedures to avoid any damage to the device. Thank you for watching, and don’t forget to like, subscribe, and share this video with your friends. Happy unlocking!
#Huawei #Frp #Bypass #TestPoint #Method
